Detach the fan heatsink clips. Place the desktop board on top of the bag component-side up. Page of 82 Go. Note the following considerations for the PCI bus connectors: Newer cards have a retention notch as shown in Figure 3.
|Date Added:||5 December 2004|
|File Size:||19.81 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Downloads for Intel® Desktop Board D815EEA
Page 77 Error Messages and Indicators Table Close the handle completely see Figure Disconnect the processor fan cable. Turn off all peripheral devices connected to the computer.
Attaching the Heatsink to the Processor Installing and Replacing Desktop Board Components Clearing the Passwords This procedure assumes that the desktop board is installed in the computer and the configuration jumper block is set to normal mode.
Attaching the Fan Heatsink Clip 7.
Intel Desktop Board DEEA – motherboard – ATX – Socket – iE Overview – CNET
Locate the processor socket and raise the socket handle completely see Figure Note the following considerations for the PCI bus connectors: By pressing ‘print’ button you will print only current page. Back panel connectors see page 66 Midboard connectors see page 67 Front panel connectors see page 68 OM Figure Do not use these connectors to power devices external to the computer’s chassis.
All of the PCI bus connectors are bus master capable. Copy the BIOS upgrade file to a temporary directory on your hard disk.
Closing the Handle 5. A fault in the load presented by the external devices could cause damage to the computer, the interconnecting cable, and the external devices themselves. Connect the processor fan cable to the processor fan connector see Figure The figure legend below lists the colors used.
Deskktop off the computer and disconnect the AC power cord. Processors A Celeron PPGA and processor For the latest information on processor support for the board, refer to the Intel desktop board web site at: The figure legend below lists the colors used.
Page 24 – Installing and Removing the Retention Me If no memory was added, there may be a problem with the system. When using notched cards, install the AGP card retention mechanism before installing the card.
The desktop board is secured to the chassis by seven screws. Intel server board technical product specification pages.
Installing and Replacing Desktop Board Components 4. Memory controller hub chipset for communications, embedded, and storage applications 40 pages.
Using the Setup Program Maintenance Menu This menu is used to clear passwords, to access the extended configuration submenu, and to access CPU information.
Place the fan heatsink on top of the processor see Figure Clearing The Passwords Installing and Replacing Desktop Board Components Clearing the Passwords This procedure assumes that the desktop board is installed in the computer and the configuration jumper block is set to normal mode.
Attach the fan heatsink clips to the processor socket see Figure Appropriate protection is provided by a maximum 8 A current limiting circuit, or a maximum 5 A fuse, or positive temperature deskto; PTC resistor.
Downloads for Intel® Desktop Board DEEA
Poor audio quality occurs if passive non-amplified speakers are connected to this output. Detach the fan heatsink clips. The connectors can be divided into the following groups: Boaard 10 shows the locations of the mounting screw holes.